The Radio Shield is an add-on kit for the Arduino development board that provides AX.25 packet radio send and receive capability, a prototyping area, [...]
The ADS-WS1 is a complete low-cost APRS weather station suitable for direct connection to a radio (no TNC required) or a PC (via RS-232). It also [...]
Note: The MX145 replaces both the 5-volt and 8-volt versions of the MX146. The MX145 is an embeddable VHF transmitter module from our friends at SRB [...]
This VHF whip antenna is factory-trimmed for optimum performance on 144.39 MHz, with good performance (typical VSWR 1.2:1 or better, see
This 16-inch antenna is intended for the 144-148 MHz band and offers a significant performance increase over our smaller antennas.
This 8-inch rubber duck antenna is designed for the 144-148 MHz band and offers better performance than the 7-inch model without being significantly [...]
Garmin part number 010-11232-10. Mini-B USB connector to serial and power pigtails, with inline converter circuit. Use this cable for Fleet [...]
This cable adapts the FC-301/D radio (without T2-301 TNC installed) to the standard 6-pin mini-DIN connection used by many TNCs. The red and black [...]
This cable is designed to simplify connection of the T2-301 or T3-301 TNC/radio combination. The yellow end connects to the tracker module, and the [...]
The APO3 is a black box designed to prevent a vehicle battery from being discharged and damaged by a DC load. Typically it is used to switch a radio [...]
Jumper, 0.1" / 2.54mm pitch, open type. This is another product that we use large quantities of in house and buy directly from the factory, so our [...]
Common DB9/DE9 right-angle female connector with PCB pins, board locks, and removable #4-40 hex jack screws. Distance from connector face to the [...]
Common DB9/DE9 right-angle male connector with PCB pins, board locks, and removable #4-40 hex jack screws. Distance from connector face to the first [...]
8-pin microphone plug, compatible with many amateur and CB radios. Datasheet (PDF)
Solderless breadboard for circuit prototyping. Adhesive-backed, stackable, with 840 contact points.
