Base unit only (not including wind and rain sensors) for the ADS-WS1 weather station. This unit includes temperature, barometric pressure, and [...]
This package includes an anemometer and wind vane for measuring wind speed and direction, a tipping bucket type rain gauge with 0.011 inch [...]
Connects the OpenTracker+ or OT2m to a handheld radio with a 3.5mm stereo mic jack and 2.5mm mono earphone jack. This configuration is used on most [...]
Connects a tracker to a handheld radio with a 3.5mm mono earphone jack and 2.5mm mono mic jack. This configuration is used on many Alinco, Yaesu, [...]
Connects a tracker to a handheld radio with a 4-conductor 3.5mm jack. This includes Yaesu models without the threaded, waterproof plug. Power is [...]
Connects a tracker to a handheld radio with a 3.5mm stereo earphone jack and 2.5mm stereo mic jack. This configuration is typical of most Icom [...]
Soft case for small radios, including the Puxing PX-777.
The Radio Shield is an add-on kit for the Arduino development board that provides AX.25 packet radio send and receive capability, a prototyping area, [...]
The ADS-WS1 is a complete low-cost APRS weather station suitable for direct connection to a radio (no TNC required) or a PC (via RS-232). It also [...]
This 16-inch antenna is intended for the 144-148 MHz band and offers a significant performance increase over our smaller antennas.
This 8-inch rubber duck antenna is designed for the 144-148 MHz band and offers better performance than the 7-inch model without being significantly [...]
This cable adapts the FC-301/D radio (without T2-301 TNC installed) to the standard 6-pin mini-DIN connection used by many TNCs. The red and black [...]
This cable is designed to simplify connection of the T2-301 or T3-301 TNC/radio combination. The yellow end connects to the tracker module, and the [...]
Jumper, 0.1" / 2.54mm pitch, open type. This is another product that we use large quantities of in house and buy directly from the factory, so our [...]
Common DB9/DE9 right-angle female connector with PCB pins, board locks, and removable #4-40 hex jack screws. Distance from connector face to the [...]
